![]() ![]() is this always the case for a FGT? or this there a way to quickly age out ARP? i.e. I also noticed this when i tried to swap a cisco ASA FW with FGT and then switch back to ASA. 250 initially and had to clear its ARP on the upstream router. 251 and i was able to ping/HTTPS immediately. I also configured the same for secondary with lan1 MGMT IP. 6x GE RJ45 ports, 4x GE SFP slots, SPU NP6 and CP8 hardware accelerated, 120 GB onboard. Lan1 address can not be deleted because role of lan1 is LAN.Ĭommand_cli_delete:6722 delete table entry lan1 address unset oper error ret=-37įW01_PRI (ha) # set ha-mgmt-status enableįW01_PRI (ha) # config ha-mgmt-interfaces 6 x GE RJ45 ports including 4 x FortiASIC-accelerated ports 2 x management ports 4 x GE SFP slots, 120GB onboard SDD. i think i also need to learn a bit more CLI if i don't fix things via GUI.įW01_PRI (address) # delete "lan1 address" thanks for your help! i need to speed up learning FGT since we're doing a HW refresh on our FW. ![]() I managed to delete "lan1 address" after i set lan1 role to "undefined". Set dhcp-relay-request-all-server disableįW01_SEC # show full system interface lan1įW01_PRI # diagnose sys cmdb refcnt show lan1Įntry used by table firewall.address:name 'lan1 address' (From VDOM: 'root')Įntry used by table router.static:seq-num '2' (From VDOM: 'root') Set switch-controller-igmp-snooping-fast-leave disable Set switch-controller-igmp-snooping-proxy disable FORTIGATE 300D Dimensions and Power Height x Width x Length (inches) 1.73 x 17 x 12.68 Height x Width x Length (mm) 44 x 432 x 322 Weight 10.5 lbs (4. NGFW performance is measured with Firewall, IPS and Application Control enabled, Enterprise Mix traffic. SSL Inspection performance values use an average of HTTPS sessions of different cipher suites. Set dhcp-relay-interface-select-method auto IPS, Application Control, NGFW and Threat Protection are measured with Logging enabled. Sn phm Sn phm ngng kinh doanh Bn quyn phn mm FortiGate-81E-POE 1 Year FortiCASB SaaS-only Service, Includes 25 users. Below are output from primary and secondary FW.įW01_PRI # show full system interface lan1 ![]()
0 Comments
Leave a Reply. |